The TPD12S016PWR is an evaluation module for TPD12S016 a single chip HDMI interface device with auto direction sensing I2C voltage level shift buffers, load switch, and integrated high speed ESD protection clamps. The device pin mapping matches the HDMI Type D connector with four differential pairs. This device offers eight low capacitance ESD clamps, allowing HDMI 1.4 data rates. The integrated ESD circuits provide good matching between each differential signal pair, which allows an advantage over discrete ESD solutions where variations between ESD protection clamps degrade the differential signal quality. The TPD12S016 provides a current limited 5V output for sourcing the HDMI power line. The current limited 5V output supplies up to 55mA to the HDMI receiver. The control of 5V OUT and the hot plug detect circuitry is independent of the LS_OE control signal and is controlled by the CT_HPD pin.
- Confirms to HDMI compliance tests without any external components
- Supports HDMI 1.4 data rate
- Match class D and Class C pin mapping
- Eight channel ESD lines for four differential pairs with ultra low differential capacitance matching
- On chipload switch with 55mA current limit feature at the HDMI 5V_OUT pin
- Auto direction sensing I2C level shifter with one shot circuit to drive long HDMI cable
- Back drive protection on HDMI connector side ports
- Integrated pull up and pull down resistors per HDMI specification
- IEC61000-4-2 (Level 4) ESD performance at all external pins
音频, 通信与网络, 便携式器材, 消费电子产品
(EN)
