The S25FL164K0XMFI011 is a non-volatile Flash Memory Device, connects to a host system via a serial peripheral interface (SPI). Traditional SPI single bit serial input and output (single I/O or SIO) is supported as well as optional two bit (Dual I/O or DIO) and four bit (Quad I/O or QIO) serial protocols. This multiple width interface is called SPI Multi-I/O or MIO. The SIO protocol uses Serial Input (SI) and Serial Output (SO) for data transfer. The DIO protocols use IO0 and IO1 to input or output two bits of data in each clock cycle. The write protect (WP#) input signal option allows hardware control over data protection. Software controlled commands can also manage data protection.
SPI Clock Polarity and Phase Modes 0 and 3
Command Subset and Footprint Compatible with S25FL-K
Normal Read (Serial), Fast Read (Serial), Dual Read and Quad Read
Serial-input Page Program (up to 256 Bytes)
Program Suspend and Resume
Uniform Sector Erase (4kb)
Uniform Block Erase (64kb)
Chip Erase
Erase Suspend and Resume
100K Program-erase Cycles on Any Sector, Minimum
20-year Typical Data Retention
Three 256-byte Security Registers with OTP Protection
Low Supply Voltage Protection of Entire Memory
Pointer-based Security Protection Feature
Top/Bottom Relative Block Protection Range, 4kb to All of Memory
8-byte Unique ID for Each Device
Non-volatile Status Register Bits Control Protection Modes
(EN)
