The MCP2562FD-E/SN is a second generation high-speed fault-tolerant CAN Transceiver guarantees loop delay symmetry in order to support the higher data rates required for CAN FD. The maximum propagation delay was improved to support longer bus length. The device meets the automotive requirements for CAN FD bit rates exceeding 2Mbps, low quiescent current, electromagnetic compatibility (EMC) and electrostatic discharge (ESD). It serves as the interface between a CAN protocol controller and the physical bus. The MCP2562FD device provides differential transmit and receive capability for the CAN protocol controller and is fully compatible with the ISO-11898-2 and ISO-11898-5 standards.
Implements ISO-11898-2 and ISO-11898-5 standard physical layer requirements
AEC-Q100 Grade 0
5μA Typical very low standby current
VIO supply pin to interface directly to CAN controllers and microcontrollers
SPLIT output pin to stabilize common mode in biased split termination schemes
CAN bus pins are disconnected when device is unpowered
Detection of ground fault - Permanent dominant detection on TXD
Power-on reset and voltage brown-out protection on VDD pin
Protection against damage due to short-circuit conditions (positive or negative battery voltage)
Protection against high-voltage transients in automotive environments
Automatic thermal shutdown protection
Meets or exceeds stringent automotive design requirements
High ESD protection on CANH and CANL, meeting IEC61000-4-2 up to ±14kV
(EN)
