The PIC18F47J53 FS USB PIM Demo Board is a full-speed USB demonstration and development board featuring the PIC18F47J53 with XLP low power. The board can be operated either standalone or as a Plug-In Module (PIM) plugged into the PIC18 Explorer Board.
- Two miniature SMT red LEDs
- 12MHz SMT crystal which can be used with internal PLL to run the microcontroller and USB module
- MCP9701A Analogue output temperature sensor
- General purpose push button S2 connected through with a pull-up resistor
- Six-pin, right-angle in-circuit serial programming (ICSP ) programmer/debug header
- Jumpers for current measurement (JP3) and configuration (JP2)
- A mini-B USB connector for power and communication
- Full-speed (12 Mbps) and low-speed (1.5 Mbps) operation
- Support of control, interrupt, bulk and isochronous transfers
- Support of up to 32 endpoints, 3.8Kbytes of dual access RAM for USB or general purpose use
嵌入式设计与开发, 工业, 医用, 车用, 通信与网络
(EN)
