The MAX5841MEUB+ is a quad, 10bit, 2-wire, serial voltage-output digital to analogue converter (DAC) in 10 pin μMAX package. The DAC with an I2C compatible, 2-wire interface that operates at clock rates up to 400KHz. This low power device operates from a single supply and draws only 230μA at VDD = 3.6V, a power down mode decreases current consumption to less than 1μA. It has a double buffered I2C compatible serial interface that allows multiple devices to share a single bus. All logic inputs are CMOS logic compatible and buffered with schmitt triggers allowing direct interfacing to optocoupler and transformer isolated interfaces. The device minimizes digital noise feed-through by disconnecting the clock (SCL) signal from the rest of the device when an address mismatch is detected. It is used in digital gain and offset adjustments, programmable voltage and current sources, programmable attenuation, VCO/varactor diode control, low cost instrumentation and ATE.
- Supply voltage range is 2.7V to 5.5V
- Operating temperature range from -40°C to 85°C
- Ultra low supply current of 230μA at VDD = 3.6V, 280μA at VDD = 5.5V
- 300nA low power (power-down mode) & power-on reset to zero
- Rail to rail output buffer amplifiers, read back mode for bus and data checking
- Three software-selectable power-down output impedances 100Kohm, 1Kohm and high impedance
- Maximum INL of ±4LSB, DNL of ±0.5LSB & 1011 10X address bit
- DC crosstalk of 30μV, wake-up time is 8μs at VDD = 5V & DAC to DAC crosstalk of 2.4nV-s
- PSRR of 58.8dB at code = 3FF hex, VDD = 4.5V to 5.5V
- Voltage output slew rate is 0.5V/μs
信号处理, 工业, 便携式器材
(EN)
