The MAX1320ECM+ is an 8-channel, 14bit, simultaneous sampling analogue to digital converter (ADC) with ±5V analogue input range in 48 pin LQFP package. The independent track/hold circuitry provides simultaneous sampling for each channel. It has ±16.5V fault tolerant inputs. This ADC converts two channels in 2μs, up to eight channels in 3.8μs and has an 8-channel throughput of 250Ksps per channel. It also includes 10MHz T/H input bandwidth, internal clock, internal (+2.5V) or external (2V to 3V) reference and power saving modes. A 16.6MHz, 14bit bidirectional parallel interface provides conversion results and accepts digital configuration inputs. The MAX1320 operates from 4.75V to 5.25V analogue supply, separate 2.7V to 5.25V digital supply and consume less than 50mA total supply current. The device has small signal bandwidth of 10MHz and full power bandwidth of 10MHz. It is used in power grid synchronization, power factor monitoring and correction, vibration & waveform analysis.
- 14bit, high speed parallel interface
- Operating temperature range from -40°C to 85°C
- Offset error of ±40LSB (unipolar devices), ±40LSB (bipolar devices) and gain error of ±8LSB
- ±0.8LSB INL and ±0.5LSB DNL (no missing codes)
- 90dBc SFDR, -86dBc THD, 76.5dB SINAD and 77dB SNR at 100KHz input
- 46mA analogue supply current, 1mA digital supply current
- On-chip T/H circuit for each channel, 10ns aperture delay and 50ps channel to channel T/H matching
- Fast conversion time of 1.6μs (1-channel), 1.9μs (2-channel), 2.5μs (4-channel) & 3.7μs (8-channel)
- High throughput rate of 526Ksps/ch for one channel
- No calibration needed
信号处理, 电机驱动与控制
(EN)
