The LTC1052CN8#PBF is a low noise zero-drift Operational Amplifier for use with strain gauge amplifiers. Chopper-stabilization constantly corrects offset voltage errors. Both initial offset and changes in the offset due to time, temperature and common mode voltage are corrected. This, coupled with picoampere input currents, gives these amplifiers unmatched performance. Low frequency (1/f) noise is also improved by the chopping technique. Instead of increasing continuously at a 3dB/octave rate, the internal chopping causes noise to decrease at low frequencies. The chopper circuitry is entirely internal and completely transparent to the user. Only two external capacitors are required to alternately sample-and-hold the offset correction voltage and the amplified input signal. Control circuitry is brought out on the 14-pin and 16-pin versions to allow the sampling of the LTC1052 to be synchronized with an external frequency source.
5μV Guaranteed maximum offset
0.05μV/°C Guaranteed maximum offset drift
0.01μV/°C Typical offset drift
100nV/√Month Excellent long term stability
30pA Guaranteed maximum input bias current
External capacitors can be returned to V- with no noise degradation
