UMFT230XB-01 breakout module utilizes FT230XQ IC to convert USB to basic UART module. UMFT230XB bridges from USB to UART IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.
- Single chip USB to asynchronous serial data transfer interface
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- Configurable CBUS I/O pin
- Device supplied preprogrammed with unique USB serial number
- Supports bus powered, self powered and high power bus powered USB configurations
- Integrated power on reset circuit
- Low USB bandwidth consumption
- UHCI/OHCI/EHCI host controller compatible
- USB 2.0 full speed compatible
通信与网络, 无线, 音频, 成像, 视频和目视, 工业, 传感与仪器, 消费电子产品
(EN)
