UMFT201XB-WE breakout modules utilize FT201XQ chip to convert USB to serial interface. UMFT201XB bridges from USB to I2C IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector. This modules operate at +3.3V voltage levels, however all I/Os are 5V tolerant.
- Single chip USB to I2C slave interface
- Up to 3.4MHz, high speed mode, I2C supported
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- Configurable CBUS I/O pin
- Transmit and receive LED drive signals
- Device supplied preprogrammed with unique USB serial number
- Integrated power on reset circuit
- UHCI/OHCI/EHCI host controller compatible
- USB 2.0 Full Speed compatible
通信与网络, 工业, 便携式器材, 消费电子产品, 无线, 传感与仪器, 系统监控
