The MC9S08QE8CLC is a 8-bit Microcontroller based on enhanced HCS08 CPU (10MHz bus) with CISC architecture operates at a maximum frequency of 20MHz. The device incorporates 8kB internal flash, 0.512kB internal RAM, 10-channel 12-bit A/D converter and 26 general-purpose I/O pins. This device also features peripherals like one inter-integrated circuit (IIC) bus module to operate at up to 100kbps, one serial peripheral interface modules (SPI) and an analog comparator. Internal clock source (ICS) containing a frequency-locked-loop (FLL) controlled by internal or external reference, precision trimming of internal reference allowing 0.2% resolution and 2% deviation. Watchdog computer operating properly (COP) reset with option to run from dedicated 1kHz internal clock source.
HC08 Instruction set with added BGND instruction
Support for up to 32 Interrupt/reset sources
Security circuitry to prevent unauthorized access to RAM and flash contents
Two low power stop modes; reduced power wait mode
Peripheral clock enable register can disable clocks to unused modules
Very low power external oscillator can be used in stop3 mode
Very low power real time interrupt for use in run, wait and stop modes
6μs Typical wake up time from stop modes
Loop-control pierce oscillator
Internal clock source (ICS)
Low-voltage detection with reset or interrupt; selectable trip points
Illegal opcode detection with reset
Illegal address detection with reset
Flash block protection
Single-wire background debug interface
Breakpoint capability to allow single breakpoint setting during in-circuit debugging
On-chip in-circuit emulator (ICE) debug module
RTC - 8-bit modulus counter with binary or decimal based prescaler
Eight KBI Interrupts with selectable polarity
Hysteresis and configurable pull-up device on all input pins
(EN)
